Kayak Building Bulletin Board Old Message Archive

This is an archived message posted to the Kayak Building Bulletin Board. If you would like to ask a question about building kayaks, you can post a new message.

Saw for Hatches

Posted by: Mike R. on November 24, 1999

I'm not sure where I got the idea, but I used a utility knife for the hatch cutouts. I just scored the surface of the plywood, then went over it again and again - it took fewer than 20 passes.

It probably took a few moments longer than a power saw, but it was very clean and precise.

Return to the Page Index or up to Kayak Building BBS Archive Index

This is an archived message from The Kayak Building Bulletin Board.

This archive and the bulletin board are sponsored by:

Guillemot Kayak - High Performance Wooden Sea Kayak Designs

Guillemot | SEE Kayak Directory | Kayak Forum | Guestbook

Maintained by Nick Schade: Info@guillemot-kayaks.com This site has been spidered by Google you can use their search engine to find information in the archive