This is an archived message posted to the Kayak Building Bulletin Board. If you would like to ask a question about building kayaks, you can post a new message.
My Brother and I saw the same boat at REI a while back. We were kiddin' with the sales guy about getting a Brewing compnay to sponsor us and we'd install littles engines for power. We could start a whole new class of racing!! Don't think he was much amused.
> I was at REI yesterday, and saw an interesting idea for a kayak. It was
> powered by a bicycle crank turning a propeller. Seemed like it had higher
> freeboard, hatches front and rear, and an open cockpit, sculpted to pedal
> recumbent style. very large gear on the pedal crank, very small gear on
> the propeller shaft.
> Steering was by a essentially vertical handle sticking up on both sides of
> the cockpit, tilt either handle side to side moved a rudder.
> The stern and transom was flat across the rear, and the bottom of the hull
> extended out past the transom to provide a shelf over the rudder and
> propeller.
> At $2800 US dollars and all fiber glass, not for me, but if it could be
> adapted to stitch and glue, it might be interesting. The sales clerk
> claimed that it was a very fast boat, which sort of makes sense, since you
> are using leg muscles rather than arm muscles to power it.
> dave
This is an archived message from The Kayak Building Bulletin Board.
Guillemot Kayak - High
Performance Wooden Sea Kayak Designs
