This is an archived message posted to the Kayak Building Bulletin Board. If you would like to ask a question about building kayaks, you can post a new message.
Sounds too simple, I'll try it tomorrow. I have been taking the scrap strip ends and cutting them into 2 " lengths and then stapling (sp?) the scrap to the form and thus avoiding the staple in the strip. this method also seems too simple to mention.
> I'm using this method all the time, but someone was over and remarked on
> it, so here it is. Tiny idea:
> I bought a bunch (30-40) of 1" spring clamps real cheap and use them
> big time, esp as I'm not bead and coving. But the tip is that I use them
> upside down about 25% of the time. For example when laying down a strip at
> a form, I put a spring clamp about 1/2" away from the strip and then
> I squeeze the handles of another one together and sproing it betw the 1st
> clamp and the strip. Actually works. Practice a bit. Put it in upside
> down, sideways or sticking up to direct the force a little bit!
> I'm also doing lots of decorative stripping and whenever the gaps get
> close to about 1" or 2" its gravy time b/c I just squeeze the
> handles together and put them in upside down. I only have to make small
> wedges for the tiny gaps. Because the handles are covered in some rubber
> coating, its soft on the strip or glue doesn't stick either.
> -mick
This is an archived message from The Kayak Building Bulletin Board.
Guillemot Kayak - High
Performance Wooden Sea Kayak Designs
