This is an archived message posted to the Kayak Building Bulletin Board. If you would like to ask a question about building kayaks, you can post a new message.
> Pygmy is closed and I have a question for those who have built the Tern. I
> have built their Coho (great boat!) - In this boat panels were aligned for
> (before glueing butt joints) by various measurments made perpendicular to
> the long axis of the panel along a strait line. (great idea in my book).
> They do not use this concept in the Tern (and would only apply for s3 and
> s4 panels as the other two have a strait edge to guide.) Does anyone have
> these measurments? - or does it not matter?. (my concern being a small
> variation at a narrow butt joint of 3s panel would be bad new 8 feet later
> on the ends. Hope this request "measures up" to this site (first
> time user!) Tom
It did not matter for me. I had no such measurements and mine went together fine.
Mike
This is an archived message from The Kayak Building Bulletin Board.
Guillemot Kayak - High
Performance Wooden Sea Kayak Designs
