This is an archived message posted to the Kayak Building Bulletin Board. If you would like to ask a question about building kayaks, you can post a new message.
> I've been busying myself this weekend glassing the hull of my Outer
> Island. I decided to do the extra football-shaped piece on the outside of
> the full layer, epoxying through both layers, and everything seemed to be
> going well. I rolled on the epoxy, used a bubble roller, and did what I
> thought was a meticulous squeegee-ing. But as I laid 2 fill coats, I
> started noticing tiny bubbles in rows in the football area -- tiny bubbles
> in the open squares between glass fibers. They were impossible to see
> while the top of the weave was still exposed, and it wasn't until the fill
> coats smoothed the surface that they became noticeable.
> I think I'll start buying my kayaks...
> Dean No one will notice these bubbles unless you point them out.Everyone who has seen my stripper have been really impressed and full of compliments and yet I have little MISTAKES in a few places!If someone notices these bubbles ask them to see thier stripper.
This is an archived message from The Kayak Building Bulletin Board.
Guillemot Kayak - High
Performance Wooden Sea Kayak Designs
