This is an archived message posted to the Kayak Building Bulletin Board. If you would like to ask a question about building kayaks, you can post a new message.
Like Ian said, they should stick to each other just fine, but I wouldn't put any structural coat of epoxy on top of a completely cured base coat. I don't think I would trust the mechanical bond to slick epoxy. Sand it lightly first if the bottom coat is cured. If it's green, just go right over it--shouldn't be a problem.
Shawn
> I'm about to run out of the sys3 epoxy. I was thinking of getting a west
> sys epoxy, to finish the job. but ! I'm not sure how will it work with the
> sys3 ? will it adhese to the sys3 ?
> thx
> erez
This is an archived message from The Kayak Building Bulletin Board.
Guillemot Kayak - High
Performance Wooden Sea Kayak Designs
