This is an archived message posted to the Kayak Building Bulletin Board. If you would like to ask a question about building kayaks, you can post a new message.
Could you use one of those 3M green scrubbing pads to scrub deeper without cutting the weave? Or was this after the first wet-out coat, and the dimples were really deep.
Shawn
> You want to get one fill coat on while the glass-coat is still green. I
> had one boat blush on me and I could not get it out of the dimples between
> the weave. The ended up with a cloudy dot where ever I failed to clean.
> However, I often put more fill coats on after glassing the outside seam
> and doing an initial sanding.
This is an archived message from The Kayak Building Bulletin Board.
Guillemot Kayak - High
Performance Wooden Sea Kayak Designs
