This is an archived message posted to the Kayak Building Bulletin Board. If you would like to ask a question about building kayaks, you can post a new message.
> I have the the deck of my Coho ready to attatch to the hull. It seams to
> me it would be much easier to cut my hatch openings now so I would have
> better access to the inside hull/deck joint for glassing. I remeber
> reading (but couldn't find) a post saying this was a bad idea. Why?
> I also remeber reading abouta handle for a jig saw blade that makes this
> job easier.I haven't been able to find this tool at any local hardware or
> woodworking store. Where can I find one?
Doyle, The handle that I used holds both jigsaw and sawzall blades and is made by Bosch. I bought mine at a Woodworkers Warehouse store. I hand cut my hatches on my coho and they are perfect. I dont trust my hand with a power jigsaw and I own a good one.
Larry C.
This is an archived message from The Kayak Building Bulletin Board.
Guillemot Kayak - High
Performance Wooden Sea Kayak Designs
